furiousgeorge
New Member
Hi all, new here and i just got my new FZ6R, burnt orange. Loving it so far but of course i have ordered a new throttle plate to remove the restriction. I have researched on the net and pretty sure i have it sussed out in regards to doing it myself but i have a few questions for anyone here who has done it. I understand i need a torx bit (25 i think?) but do i need one with the hole in the middle, as in does the screw have a pin in the middle of it? If so where did you get it? Also are the throttle cables a pain to remove, do they only need to be removed at the plate end (not the bar end) and is there much room for damage to be done to the throttle cables whilst doing this? I ask because for obvious reasons i would like to do the work myself, but if i dont think i can i will talk to mechanic about it.
Thanks in advance
Thanks in advance