• Welcome to the Yamaha FZ6R Forums. Member registration disables ads and allows you to post and share. Register Here.

Still popping on deceleration

FZ6Rican

New Member
Joined
Jan 21, 2012
Messages
5
Location
Tampa, fl
Visit site
NOOB needs help

I got the Two Brothers Exhaust, Juice Box Pro, and Graves block off plates and the freaking thing is still popping. I've tried the stock map which was horrible, the Two Bros. full exhaust preloaded map, Marthy's sport sport rev a, and Marthy's touring rev d which was the best. It is better with Marthy's maps but it still pretty significant. If anyone has any tips for me it would be greatly appreciated.
 
Make sure all the nuts are tight on the header flanges and the gaskets are sealing good. Any exhaust leaks will let fresh air into the exhaust, mix with unburnt fuel, and POP your annoyed. Good luck man.
 
I checked and everything seems to be as tight as I can get it so I guess I am just going to have to deal with it for now because the wife says that my bike is cut off from the bank account.
 
Mine is a UK model (XJ6 Diversion F) with an arrow full system, O2 sensor is about the only difference.

Pops on deceleration when cold, fine when engine hits temp (70 degrees C).

Personally I don't care in that I like the noise/flames... Unless I am damaging something?!
 
Last edited:
I just bought an 09, with a Two Brothers exhaust, and it pops like crazy on decel. On the test ride I didn't give it much thought, just chalked it up to the pipe. Man this thing is obnoxious, pretty sure my neighbors hate me at this point. I'm not so worried about that. Can this be damaging the engine at all?
 
Sounds like your bike needs a good tuning. Bring it to a shop, get it dyno'd. My bike was very poppy too before the tune. After, everything was so smooth (note: I don't have a two brothers system, but all same shit)
 
Back
Top