2013 FZ6R Stator Cover Replacement

[yasnomas]

Hi, I need to replace the stator cover on a 2013 fz6r. Does anyone have any experience with this, that can guide me as to how to do the replacement, exactly. I'm a layman. I bought the cover and a new gasket, need steps and to know what to look out for, any parts etc..? Thank you.

 

[Bert-Aus]

If it's only the cover
Drain the oil
Remove the old cover
Check for anything obvious in wrong place
Remove old gasket and clean the seam with a dry clean rag
Place new gasket in place
Install new cover, as with any casing, finger tighten diagonally opposite bolts and then torque set bolts in same manner
Refill your oil, job done in 20mins


Sent from my C6903 using Tapatalk

 

[alaskanflyboy]

7.2ft/lbs on the bolts as well. I don't have a torque wrench that goes that low, so I figure just past finger tight on those things.

 

[yasnomas]

Thank you so much for the info. As for looking out for anything that doesn't belong. I was wondering if there are any wires attached to the stator or any small parts inside when I open it that I should be careful for?

THANKS

 

[Rumpig]

This page shows the breakdown of all the parts. http://www.bikebandit.com/2011-yamaha-fz6r-fz6rab/o/m144346#sch681173

We can't post a copy of the manual but it is out there on the internet, google it.