Hi all,
may be a stupid question here; ive tried looking it up and could find any information on doing specifically this.
lets say, I was to spin up some maybe 8mm spacers on a lathe, take the fork caps off, insert the spacer over the inner tube above the spring, and put the cap back on, am I going to have any problems like spring bind or bottoming out?
I know the better solution is to replace to a stiffer spring, different weight oil, but just a thought for now.
any thoughts? anyone done it and nearly killed them selves?:zombie:
may be a stupid question here; ive tried looking it up and could find any information on doing specifically this.
lets say, I was to spin up some maybe 8mm spacers on a lathe, take the fork caps off, insert the spacer over the inner tube above the spring, and put the cap back on, am I going to have any problems like spring bind or bottoming out?
I know the better solution is to replace to a stiffer spring, different weight oil, but just a thought for now.
any thoughts? anyone done it and nearly killed them selves?:zombie: