sensor

Hi everyone, I have had a search for the answer to my question but could only find bits and pieces so I thought I would ask here. I have just installed a Two Brothers exhaust on my 2014 fz6r I am going to get a mate to weld a bung in for the O2 sensor. My question is do I actually need a...

Hello, i am new to this forum and really wanted some help. I just purchased a 2012 FZ6R. i wanted to install a gear indicator (Healtech GiPro X y-01). I am so confused with the wiring. i think i am ok with the +12v connection and the speed sensor (3 pole under the gas tank). My confusion/problem...

Just wanted to post this story to try to save someone else time. I searched around and it seems no one else has posted this problem before. Yesterday my neutral safety switch died. When I pulled up to my moto club it was working fine, then when I went to leave the bike would start, but as...

what i did was go into my factory FZ6R manual and looked under the air intake temperature sensor values. 32 degrees F the OHMs should be about 5.5k-6.6k and around 175 degrees the OHMs shound be around .223k-.235k ohms. what the sensor does is messure the intake air temp with a OHM resistor and...