I've read all the threads about risers/barback risers and various Renthal bars but haven't seen anything about changing out the stock bars for Renthal 756-01 bars. If I'm reading the Renthal application chart correctly, those bars have a rise of 105mm. The stock bars measure about 60mm rise I think, anybody know for sure? That would give approx. 45mm (i.e. 1 3/4 in.) additional rise. If I'm correct and the 756-01 bars will work, I'm thinking that is a better solution to raising the bars than bar risers and keeping the stock steel bars. It would be achieving a 1 3/4 in. bar raise and upgrading the bar to reduce vibrations at the same time. Anybody done this with these bars? Am I on the right track or am I missing something?