2014 FZ6R Exhaust Question

[Ashole]

Hey everyone! New rider here just picked up a 2014 FZ6R and am not a fan of the stock exhaust, to quit! I am leaning towards a Delkevic Full 4-1 Exhaust so I don't have to do any welding plus I like it Loud

I have been reading some other forums on here and realizing I need to get more things for this to work? Power Commander, PC Maps?

Anyone willing to tell me everything I need to make sure it runs clean and sounds the best?

Thanks in advance!

 

[arwolc]

Hello. I want to modify my exhaust too, but I read that, If You have lambda sensor, You don`t need to modify ecu maps, but I really dont know. Maybe, someone could share his experience?

 

[jacobg98]

I have a 2012 FZ6R and I got a good deal on a used Delkevic system. It's the full system w/ the 8" round stainless muffler. Besides that, I have done no other performance mods (yet lol). I run it with the baffle and it does just fine. It does pop a little on decel, but the Delkevic website does say on their website that the bike should not require any retuning.

 

[Marthy]

If you use the DBkiller you'll be fine without a PCV. You won't get any extra whoomph LOL but it will be noisy.

As far as popping go on decel, block off plate would fix that. Fit you want to go the cheap way you can disconnect the hose on the RH side, top of airbox. Duct tape the nip on the airbox close and put he hose over the tape. Basically want to block the air to pass through the hose from the airbox to the AIS.