Looking for a PCV + maps

[Lago]

Hi, just wondering if anyone is selling a Power commander, I am located in Sydney Australia.
Also does anyone have access to Marthys maps or able to email them to me as his website is now offline, cheers.

 

[DiHydro]

The power commander website has some good base maps, and now they have an app to tweak the PCV with your phone. I am going to try the phone thing today so I can report back.

 

[dart1963]

got these before the site was closed. usual disclaimer applies!

 

[MDFZ6R]

Maps

I just got a Power Commander FC. Does anyone have the sport or touring Rev B maps? I dont think I can use ADVgear due to the lack of a speed sensor.

 

[Zyra Yttrionus]

Thanks!!!!

got these before the site was closed. usual disclaimer applies!

Thanks a gazillion! I've been looking for these for a few days! :zombie:

 

[Zyra Yttrionus]

I have the same issue. I'm not sure where to find one either. Has anyone bought a speed sensor to hook up to the PCV?

 

[dart1963]

I have the same issue. I'm not sure where to find one either. Has anyone bought a speed sensor to hook up to the PCV?

it's not a separate sensor, it's a tap into the speed sensor already on the bike, but I'd have to dig around to find which wire it was as I don't have mine any more

 

[Final Impact]

The speed sensor is a 3 wire sensor in line with the output shaft of the transmission. The blue and black wires are ground and power. You tap the other one which is output from the sensor. Find the sensor and trace it back. Try not to tap it where moisture off the tire is present. Get up under the tank.

The Bazza Z-FI unit I have only used one tap and that was for Nuetral indicator, a single wire. Everything else plugs in direct.

 

[Chris12]

I have the same issue. I'm not sure where to find one either. Has anyone bought a speed sensor to hook up to the PCV?

I know Final already addressed this, but here's the last page of the install instructions for the PCV (FZ6r model):

http://www.powercommander.com/downloads/22-008/install/pcv/engI22-008.03.pdf

 

[Kawasaki66]

got these before the site was closed. usual disclaimer applies!

Thanks mate!!

 

[tho9504]

this could be a dumb question: What is the purpose of the power commander?

Does it increase speed / torque, etc?
Do you need an new exhaust after installing the power commander?

 

[Scott_Thomas]

The power commander bypasses your bikes stock ECU and allows you to select or make better fuel maps. Different exhausts and other engine changes will affect how your bike receives and burns fuel. The PC5 can custom map your fuel to get the most out of your modifications. Tuning properly can add some hp, but probably negligible if you don't add a full exhaust or cams, etc.
At least that my understanding of the purpose of the PC5. Someone else may have a more precise answer (Marthy).

this could be a dumb question: What is the purpose of the power commander?

Does it increase speed / torque, etc?
Do you need an new exhaust after installing the power commander?