How to install new clutch and front brake hand levers?

[51adwsu biker]

How do you install clutch and front brake hand levers? pics?:surrender::surrender:

 

[Roaddawg]

How do you install clutch and front brake hand levers? pics?:surrender::surrender:

Here's a 19 page prior thread to get you started: http://www.600cc.org/forum/f89/new-levers-19394/

 

[51adwsu biker]

Went through the entire post, nothing about how to do it, just talk about what they were doing, someone please help

 

[dart1963]

Went through the entire post, nothing about how to do it, just talk about what they were doing, someone please help

with the exception of the tip on the "cheap" levers and grinding the bar a bit on the brake lever... this is really one of those "simple" mods.... the levers are held in place by a bolt...

unscrew the bolt
on the clutch, carefully remove the cable
then reinstall the new levers.... (use a bit of loc-tite on the threads sparingly)

if you can't figure it out aside from that... and please don't take any offense, 'cause I don't know you and don't know your skill level on maintenance... you probably need to get someone else to help (physically there) or get it done at a shop.

There is no tension on the clutch cable, so there's no worry about anything falling out of place, there is nothing on the brake side you can mess up, all the hydraulics are contained separate from the lever.

Good luck.

 

[FZ6R-Canada]

There are also some useful videos that demonstrate this on u-tube.
It is on different bikes but the principle is the same. Just do a search.