Hi; My 6 month old Boykin puppy decided my service manual look good enough to eat. My Haynes manual is # 5889 Yamaha XJ6 & FZ6R 09-15. He destroyed 6 pages. The last four in Bodywork 7-5, 7-6, 7-7 & 7-8. The first two in Electrical 8-1 & 8-2. If anyone has this manual would you scan these six...
Hi; As many of you know our FZ6R's have no oil pressure gauge or warning light. The bikes have an oil LEVEL warning light but that's it. It's always bothered me that my oil pump could fail and I would not know it until the engine locked up. I've had oil pump failures twice on machinery...
Hi;
I am looking for a one piece seat for my 2013 FZ6R. Stock on my bike is a 2 section seat. Will a one piece seat from a 2006 FZ6 fit my FZ6R? I would need it to lock down just as my stock seats do. I am hoping a one piece seat will let me ride further back on the seat. Also maybe more...
I removed the catalytic converter. Installed block off plates and removed total AIS system. Changed to non resister plugs. Used a Morgan Carbtune manometer to balance my carbs. Throttles better, sounds better and is a lot cooler. Put on a set of Yamaha sliders and added a Healtech GiPro gear...
I am going to change my flasher for the type that flashes correctly for LED's. Does anyone know how many posts are on my 2013 FZ6R flasher? Some sites call for a two post flasher and some for a 4 post flasher.
Thanks; Tom
I cut open the bottom of my stock exhaust as shown by Johnny Watts in his How to Stock Exhaust Mod-Hard Mode. The only cutting I did on the inside was to remove the catalytic converter material and part of the pipe surrounding it. The interior of the converter was extremely hard. Stripped the...
Is there such a thing as a factory OEM center stand for our FZ6R's ?
All I can find is an aftermarket made by SW-MOTECH that fits FZ6R & FJ6 Diversion. 2009 to 2015. Does anyone have a factory center stand? Did it
come on the bike when new or was it an accessory? If so does anyone have the...
Hi; As I have not been here long someone may have already posted this. I was trying to figure out how to put an oil pressure gauge on my FZ6R. Yamaha sells an adapter to hook up a gauge but it cost about $80.00 shipped from a discounter. Over $100.00 from Yamaha. The Yamaha unit is made to...
HI; New 2013 FZ6R owner here. Do anyone know of a web site where you can enter your bikes serial number and get a list of factory service bulletins that effect your bike?
Thanks; Tom